DIY Kits – ELF AS3 (2025) Master Chassis

Complete ELF-Sabers AS3 (2025) Master Chassis DIY kit.
The chassis will be printed on-demand for this order, and shipping is normally expected 2 month after ordering.

It includes a complete chassis, with possibility to add accessories and all electronic components to install it. (see list below).
It can also include the hilt for a all-in-one purchase

3 Variants available
– Metal chassis kit only
– Metal chassis kit + Electronics components and other parts
– Metal chassis kit + Electronics components and other parts + ELF AS3 2025 hilt

New AS3 Master Chassis design 2025
New Dual Motor Chassis design!

Notes:
– Tools to perform the conversion are not supplied.
– Weathering chemicals are not supplied.
– Heatshrink tubing are not supplied.
– Keepower Battery not included (can be purchased from the DIY Parts Section of the shop).
– This is a DIY kit and isn’t not delivered installed. It is an advanced level build as shown in these DIY instructions, for experienced installers. If you would prefer to have this installed for you, look into our Sabers and Props section.

Please read our Terms and Conditions.

Prices are displayed excluding Shipping, VAT (both calculated at checkout) or Custom Taxes.

Shipping: On demand – Shipping in approx.. 2 months after ordering.

Ship from France

International customers (out of EU):
Option for Duties & Taxes Paid = for a small upfront fee, no additional duties will asked to be paid at delivery.

Return policy: No return accepted on this item.

Order cancellation policy: Being on-demand printing, this order cannot be cancelled. Make sure to have thoroughly read everything including build instructions.

Parts included in this kit:

CHASSIS
Complete AS3 Master Chassis
Mix of brass and steel, with PA12 Soundboard chassis and 3D printed crystals (can serve a template to shape real quartz).

Note: Steel parts will require deburrign and polishing (a Dremel is sufficient for this task).

COMPONENTS LIST:

– ProffieBoard 3.9 x1
– 28mm 4ohm 3W Bass Speaker x1
– High Amp Kill Switch x1
– Brass Tactile Switches (4mm) x2
– MICRO MOTOR 47 RPM x1
– MICRO MOTOR 6400 RPM x1
– Blade Connector – Short Pins x1
– 5mm Crystal Pixel PCB x1
– Large  pixels ring x2
– 5mm pixel strip – 12 LEDs x2
– 5mm pixel strip – 6 LEDs x1
– 3.5mm pixel strip – 8 LEDs x1
– 1.5MM BRASS ROD – 2 x 10mm
– 3mm OD Copper Tube – 3 x 32.2mm
– 4mm OD Copper Tube – 2 x 23.3mm
– OLED Screen x1
– 2mmx2mm Magnets x8
– M1.6 socket screw 4mm length x9
– M1.6 socket screw 5mm length x2
– M1.6 nuts x 11
– M2 socket screw 8mm length x3
– M2 nuts x 3